cdot3OamMode

• 1.3.6.1.4.1.9.10.136.1.1.1.3
• Access readwrite
• Type active(1), passive(2) ?

  active(1), passive(2)

  This type is not a standard SMI/SNMP base type and is not defined as a documented TEXTUAL-CONVENTION in this MIB.

  It was extracted as raw syntax from the source MIB file and could not be resolved to a known type definition.

This object configures the mode of OAM operation for this Ethernet like interface. OAM on Ethernet interfaces may be in 'active' mode or 'passive' mode. These two modes differ in that active mode provides additional capabilities to initiate monitoring activities with the remote OAM peer entity, while passive mode generally waits for the peer to initiate OAM actions with it. As an example, an active OAM entity can put the remote OAM entity in a loopback state, where a passive OAM entity cannot. The default value of cdot3OamMode is dependent on the type of system on which this Ethernet like interface resides. The default value should be 'active(1)' unless it is known that this system should take on a subservient role to the other device connected over this interface. Changing this value results in incrementing the configuration revision field of locally generated OAMPDUs (30.3.6.1.12) and potentially re-doing the OAM discovery process if the cdot3OamOperStatus was already operational(9).