tmnxPtpVRtrIfAdminState
1.3.6.1.4.1.6527.3.1.2.74.2.4.1.1
The value of tmnxPtpVRtrIfAdminState specifies the administrative
state of the PTP hardware assist configuration of the interface.
If the value is 'inService(2)', the timestamp point for PTP event
packets is configured to be the physical layer. This corresponds to
timestamp point 'A' in IEEE 1588-2008, Figure 14.
If the value is 'outOfService(3)', the timestamp point for PTP event
packets is configured to be the operating system kernel. This
corresponds to timestamp point 'B' in IEEE 1588-2008, Figure 14.
The value may only be configured to 'inService(2)' if all of the
following are true:
1. An IPv4 address is configured against the interface.
2. An Ethernet physical port (or VLAN tag on an Ethernet physical port)
has been associated with the interface.
3. The Ethernet port associated with the interface must not be
configured for WAN mode. In other words, the tmnxPortEtherXGigMode
attribute for the port must be either 'notApplicable' or 'lan'.
4. The MDA associated with the interface has synchronous Ethernet
enabled. In other words, the tmnxMDASynchronousEthernet attribute
for the MDA must be 'enabled'.
5. The port associated with the interface is on an IOM that supports
the hardware assist configuration.
6. The port associated with the interface supports the hardware assist
configuration.
7. The firmware currently in use by the active CPM support the hardware
assist configuration.
8. The firmware currently in use by the IOM card supports the
hardware assist configuration. After an upgrade from an older
release, the IOM may continue using older firmware. A hard reset
of the IOM is then needed to bring the IOM firmware up to date.
9. The firmware currently in use by the MDA supports the hardware
assist configuration. After an upgrade from an older release, the
MDA may continue using older firmware. A hard reset of the MDA or
IOM is then needed to bring the MDA firmware up to date.
If the physical port bound to the interface is removed,
tmnxPtpVRtrIfAdminState is set to 'outOfService(3)'.
If the IPv4 address assigned to the interface is removed,
tmnxPtpVRtrIfAdminState is set to 'outOfService(3)'.