atFilev2MoveBegin
1.3.6.1.4.1.207.8.4.4.4.600.3.8
A read on this object can return several possible values,
depending on the current status of the system and the various
file operation objects:
idle There is no file operation
in progress and all required
objects have been set
correctly. Setting a '1' to
this object will begin the
file move.
Error codes: [1-6] A move operation cannot be
started until these errors
are resolved. See below for
key.
[action]ing x [--> y] A file operation is
currently in progress. You
cannot start another
operation while the object
is returning this value.
[action] x [--> y] success The last copy, move or
delete operation was
successfully completed.
[action] x [--> y] failure: [err] The last copy, move or
delete operation failed,
with the error message
attached. Common failures
include lack of space on the
destination file system,
incorrect source file names
or communication errors with
remote services.
Upon reading a success or failure message, the message will be
cleared and the next read will result in either an 'idle'
message or an 'Error codes' message if not all required objects
have been correctly set. If a read returns 'idle', a new file
operation can be started.
Error codes for file move:
1 - atFilev2SourceDevice has not been set
2 - atFilev2SourceFilename has not been set
3 - atFilev2DestinationDevice has not been set
4 - atFilev2DestinationFilename has not been set
5 - either atFilev2SourceDevice or atFilev2DestinationDevice
are set to TFTP
6 - the combination of source device, stackID and filename is
the same as the destination device, stackID and filename
(i.e. it is not valid to move a file onto itself.
Note that if the above requirements are met and the operation
would result in a system file being modified or deleted, then
an SNMP set to this object will be disallowed.
For valid operations, immediately upon executing the SNMP set
operation on this object, the file move will begin and will
continue on the device until either it has completed, or a
failure occurs. For large files, operations can take several
minutes to complete.
Subsequent reads of the object will return one of the messages
shown above, to track the progress of the move operation.