backupCnfgPath
1.3.6.1.4.1.207.8.4.4.4.500.3.4.1
The full path of the backup configuration file to be used the
next time the device restarts, if the boot configuration file
cannot be accessed. There is no guarantee that the file
referenced exists (i.e. it may have been deleted since the
backup configuration path was last set).
Only one set operation can be executed at a time across all
SNMP users, and an operation may not be started unless the
current value of backupCnfgSetStatus is 'idle'. The path must
not contain whitespace characters.
Immediately upon setting this object, the system will attempt
to set the new backup configuration path, and the process will
continue on the device until it has completed or a failure
occurs. The current status of the operation can be determined
by reading backupCnfgSetStatus, and the result of the last
completed operation is indicated by backupCnfgLastSetResult.
This object can be set with an empty string in order to clear
the current backup configuration. Otherwise, the path should be
of the form 'flash:/filename.cfg' or 'card:/filename.cfg'.
There are several requirements that must be met in order to set
a backup configuration file successfully:
- The file must exist.
- The file must be in the flash (on the active master in a
stacked environment) or card filesystems.
- The file must have a .cfg suffix.
- In a stacked environment, there must be enough disk space
available to store the configuration file on each stack
member.