ConfigRegisterValue
An Integer containing the value of config register. The definition of individual bits from right to left when set are as follows: 00 to 03 Boot Fields(Refer below for explanation). 04 to 05 Not Used. 06 Causes system software to ignore the contents of NVRAM. 07 Enable the original equipment manufacturer (OEM) bit. 08 The Break function is disabled. 09 Not used. 10 Broadcast based on 0.0.0.0 IP address. 11 to 12 Defines the console baud rate as below: Bits 11 & 12 unset: 9600 baud(default), Bit 11 set & 12 unset: 4800 baud, Bit 11 unset & 12 set: 1200 baud, Bit 11 set & 12 set: 2400 baud 13 Boots default Flash software if network boot fails. 14 IP broadcasts do not have network numbers. 15 Enables diagnostic messages and ignores the contents of NVRAM. Meanings for different values of Boot Fields (Bits 00 to 03) are explained below: Value(in hex) Description ------------ ----------- 00 On powerup or reload, the system remains at the ROM monitor prompt (rommon>), awaiting a user command to boot the system manually by means of the rommon boot command. 01 On powerup or reload, the system loads the system image found in onboard Flash memory. 02 to On powerup or reload, the system loads 0F the system image specified by ceExtSysBootImageList. It tries to boot the image in the order in which the image names are entered in ceExtSysBootImageList. If it cannot boot any image in the ceExtSysBootImageList, it stays in ROM monitor mode.