loadStatus

• 1.3.6.1.4.1.207.8.4.4.4.48.2
• Access readwrite
• Type idle(1), wait(2), loading(3), complete(4), reset(5), actionload(6), actionstop(7), actionupload(8) ?

  idle(1), wait(2), loading(3), complete(4), reset(5), actionload(6), actionstop(7), actionupload(8)

  This type is not a standard SMI/SNMP base type and is not defined as a documented TEXTUAL-CONVENTION in this MIB.

  It was extracted as raw syntax from the source MIB file and could not be resolved to a known type definition.

Status and action object for the load module. The values 1 to 5 are read-only values and reflect the state of the load module. Values 4 and 5 (complete and reset) are 'read-once', that is, if their values are read, either by SNMP or by manager console command, then they will be changed back to idle(1). The action values (6,7,8) cause a start and stop of the load/upload process respectively. Starting the load/upload can only occur if this field has the values 1, 4, or 5. Stopping the load can only occur is this field has the values 2 or 3. Reading the value of the loadStatus after one of actionstart or actionstop has been set will give one of the values 1 to 5. Note: A single exception to the above rules is that if the value of loadStatus is idle(1), then a write of 1 to this variable will succeed without generating an error. This exception is to allow certain SNMP test suites to test this variable without throwing up errors.